Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cambria Driveway & Pavers: The Sacramento Owner’s Guide
If you have a Cambria driveway or paver surface in Sacramento and a section has failed, we can match the replacement material, handle the removal, and install new pavers with a written price before any work starts. Typical paver driveway installation runs $7,000 to $18,000 in Sacramento; a smaller repair or partial paver replacement usually lands between $1,200 and $4,500 depending on square footage, substrate condition, and whether we’re matching existing Cambria product or installing a compatible equivalent. You’ll usually spot the failure the same way every homeowner does: a sunken edge near the garage apron, a paver that’s cracked down the middle after a wet winter, or a low spot where water pools instead of draining toward the street.
One thing to understand up front: Bradford Remodeling Co Sacramento is an independent contractor, not a Cambria dealer or factory affiliate. We work with Cambria product because it’s specified on enough Sacramento jobs that we know its sizing and behavior, but we also install Belgard and Unilock pavers where the situation calls for it. Cambria is known primarily for quartz surfaces, and when it comes to hardscaping, what you’re usually dealing with is a paver or stone product that was installed as part of a larger landscape or exterior package. Our job is to make sure the replacement matches, drains correctly, and stays flat.
Which Cambria Models This Applies To
Cambria’s exterior hardscape line is limited compared to its interior quartz program, so the first step is identifying exactly what you have. Most Sacramento driveways we see labeled “Cambria” fall into one of two categories: modular concrete pavers in a 3-piece or 4-piece system (typically 60mm or 80mm thickness for vehicular use), or natural stone slabs cut to paver dimensions. If you have a modular system, check the underside of a removed paver for a stamped mold number and size code. If it’s natural stone, measure the thickness in millimeters: 30mm is pedestrian only, 50mm and up can handle vehicle loads.
The compatibility gotcha most homeowners miss: Cambria modular pavers are often part of a specific pattern repeat, not a simple square or rectangle. If you replace one broken paver with a generic big-box product of similar color, the pattern breaks. We keep a measurement log on every Cambria job we touch so we can order the correct mold shape and not guess at the yard. For older installations where the exact Cambria SKU has been discontinued, we source a dimensionally matched aftermarket paver and do a full section replacement rather than a single-unit patch that will look wrong for years.
Styles & brands we work with
Signs Your Cambria Driveway & Pavers Is Failing
- Edge pavers sinking or separating from the border course. This almost always means the edge restraint has failed or was never installed properly. Without a solid edge, the entire field starts to drift and open up.
- Low spots that hold water more than 48 hours after rain. Sacramento’s wet winters expose base problems fast. Standing water means the base has settled or washed out beneath the pavers.
- Hairline cracks spreading across multiple pavers in a line. A single cracked paver is usually impact or a manufacturing flaw. A line of cracks across several pavers means the base is flexing under load.
- Weeds or grass pushing up between joints from below. This tells you the joint sand is gone and the base has organic material in it. It will only get worse.
- A paver that rocks or shifts when you step on it. The bedding layer has likely eroded from underneath. If left alone in Sacramento’s clay-heavy soil, the movement gets more pronounced each season.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a full paver driveway installation in Sacramento, budget $7,000 to $18,000. Driveway replacement, if we’re removing the old surface and starting over, runs $5,000 to $14,000. A partial repair where we cut out a failed section, recompact the base, and reset pavers typically costs $1,200 to $4,500. The range depends on three things: total square footage, whether we’re excavating and hauling off old material or working over a salvageable base, and whether your Cambria product matches current stock or requires a section swap with a compatible line.
Everything we quote includes removal of the failed material, base prep per manufacturer spec, the pavers themselves, joint sand, and a clean job site at close. You get the written price before we start, and the 365-Day Done Right Promise covers the installation for a full year. If the work doesn’t hold, we come back and correct it at no charge. No numbers moving at the door, no change orders written on the back of a receipt.
DIY or Call Us?
A homeowner can safely inspect the problem: check for standing water, measure the affected area, and note whether the base under a lifted paver is wet sand or solid crushed rock. What you should not do is start pulling pavers out of the middle of a driveway. Once you break the pattern and disturb the bedding layer, you’re into a much larger repair than the original crack. Improper lifting near an edge can also collapse the restraint and let a whole course shift.
The honest answer: single paver replacement is a weekend job for a careful DIYer with the exact matching unit in hand. Anything beyond that needs compaction equipment, base material, and a trained eye for drainage. Curtis Lane has run crews across Sacramento long enough to tell you the second attempt usually costs more than the first call. Call (279) 226-1509 and we’ll give you a straight read on what you’re actually dealing with.
FAQs
A properly installed modular paver driveway lasts 25 to 40 years in Sacramento, with the pavers themselves rarely failing before the base does. The real wear points are the joint sand, the edge restraint, and the base material under heavy vehicle traffic. Summer heat doesn’t crack concrete pavers directly, but our clay soil expands and contracts enough that a poorly prepared base will telegraph movement to the surface within a few seasons.
In most cases, yes. If the base is sound and you have matching pavers available, we cut out the affected area, recompact the bedding, and reset the section. The repair only becomes a replacement when the base has failed across a wide area or the pattern can’t be matched. Call (279) 226-1509 and we’ll tell you which situation you’re in before you spend a dollar.
A partial paver repair usually takes one to two days in Sacramento. A full driveway replacement runs five to eight working days depending on excavation depth, base depth, and whether we’re working around an existing garage slab. We’ll give you the timeline in writing with your estimate, and it won’t drift once the job starts.
We stock common replacement pavers for the brands we install regularly, including Belgard units and common modular shapes. Cambria exterior hardscape product is generally ordered per job after we confirm the exact size and mold. We also work with Silestone and other documented brands on interior work, but for driveway pavers, the match is usually Cambria or a compatible Belgard or Unilock line.
Written by Curtis Lane, Owner, Bradford Remodeling Co Sacramento at Bradford Remodeling Co Sacramento, serving Sacramento and nearby areas.
